Angle grinder do not install woodworking saw blades, universal tools, potential killers

Electric Angle mill because of its powerful and gradually promoted, set cutting, grinding, grinding and other functions in one, but the safety risks of the Angle mill is also the largest of all electric tools, the purchase of Angle mill should pay attention to safety protection, in the work should be strictly in accordance with the requirements of all protection.

The working principle of the Angle Grinder
First of all, to understand the structure of the Angle grinder, the Angle grinder is mainly composed of a handle, protective cover, cutting/grinding plate and pressing flange and other components.

The Angle grinder uses alternating current or direct current (rechargeable battery) as the power source to drive the motor to rotate at high speed and drive the cutting sheet or grinding sheet to rotate.

Operating specification for Angle grinder
1. Wear a protective eye mask.
2. After opening the switch, wait for the grinding wheel to rotate steadily before it can work.
3, long hair workers must tie up their hair first.
4, the cutting direction can not be towards people.
5. Stop working for 15 minutes after half an hour.
6, can not grasp small parts by hand diagonal mill processing.
7, after the completion of the work consciously clean the working environment. How to install the Angle grinder plate Take out the Angle grinder, prepare to install the Angle grinder baffle plate, and tighten the fixing nut of the Angle grinder with the screwdriver. After tightening, you can install the cutting sheet. When installing the cutting sheet, first place the cutting sheet on the top of the Angle grinder, and then use the fixing nut to stabilize the cutting sheet. Use the wrench to tighten the nut. Make sure that after the nut is tightened, you can install the handle on the side of the Angle mill. Note that the installation sequence of the Angle mill cannot be reversed, and the fixing nut must be tightened during this process.

Attention!!
Angle mill protective cover should not be removed at any time, always let the side with protective cover to the operator, if you must remove the protective cover to work, then find a professional alternative tool to use, do not risk using in order to save time.

At high speed, the grinding wheel is cut by many fine particles in contact with the workpiece, although the cutting is slow, the reaction force generated is very small; The sawtooth of the woodworking blade is large, and the reaction force is also large. If the reaction force generated by the hard object is encountered at a high speed, the hands can not be controlled at all, which is also the reason for many Angle grinding machine accidents.

Therefore, as a hand-held power tool, the Angle grinder is changed to a woodworking saw blade for cutting wood is extremely unsafe.